EV Charger Installation in Firestone, CO

Most Firestone EV charger questions are actually permit questions. The Town’s submittal list names four documents, the code amendment for attached garages adds a fifth item most homeowners have never heard of, and an installer who has not read them will lose a week at inspection. Precision Service Electric installs Level 2 chargers in Firestone and files the Town permit as part of the job. Call 970-593-3190.

Electrician installing a Level 2 EV charger on a garage wall in Firestone, Colorado.
Illustrative design concept of a Firestone project.

Level 2 Charging for a Firestone Commute

Firestone sits on the I-25 corridor, and the car’s daily distance is what decides the charger. A household that drives twenty miles a day can live on the cord that came with the car, adding three to five miles of range per hour on a 120-volt receptacle. A commute to Denver, Boulder County or Fort Collins changes that arithmetic and a 240-volt circuit becomes the practical answer, adding something in the range of twenty to thirty miles of range per hour depending on the vehicle’s onboard charger.

Hardwired versus plug-in is the next decision. A suitably rated hardwired unit can support a higher charging current than a typical plug-in installation on a 14-50 receptacle, and it removes a plug-and-socket connection from a circuit that runs for hours at a time. A plug-in unit on a NEMA 14-50 receptacle is easier to move, which matters in a rental or a house where the next owner may not have an EV.

Your Panel Comes First

Firestone requires a load calculation with the permit, so the panel arithmetic is not optional paperwork — it is the spine of the job. The question is whether the existing service can carry a continuous load of thirty-two, forty or forty-eight amps on top of everything else in the house.

Charging current is not the breaker rating. A 48-amp charger needs a 60-amp breaker, a 40-amp charger needs 50, a 32-amp charger needs 40, because electric vehicle charging is treated as a continuous load at 125% of its current. On a 100-amp service carrying a heat pump and an electric range, the honest answer may be a lower-amperage circuit rather than a service upgrade — and sometimes it is the upgrade, which is why it is settled before hardware is ordered.

The Attached-Garage Heat Detector

Firestone’s adopted code amendment is the detail that separates a compliant install from a failed inspection: when an EV charger is installed in an attached garage, the town requires a heat detector wired into the home’s smoke alarm system. It is not a standalone battery unit on the ceiling; it is an interconnected device.

Practically, that means the charger circuit and the alarm circuit are planned together, and the submittal has to show it — the Town’s documentation list calls for a floor plan that locates the equipment and the interconnected heat detector, alongside the load calculation, the equipment specification and a wiring diagram showing the point of connection, overcurrent protection and conductor sizing.

Battery Storage, If That Is Next

If the household is planning a battery alongside the charger, Firestone’s published requirements list energy storage systems as UL 9540-listed and restrict where they may be installed — a detached garage or accessory structure, an exterior wall of an attached garage, or outdoors at least three feet from doors and windows into the dwelling — with sleeping rooms and closets opening onto them excluded, and per-unit and aggregate capacity limits that carry their own conditions and exceptions. We check the current requirements for the specific equipment before quoting.

None of that is a reason to avoid storage; it is a reason to plan the location before the equipment arrives.

United Power Rebates

Firestone’s electricity comes from United Power, a member-owned co-operative — not Xcel, and Xcel’s programmes do not apply here. United Power publishes a residential EV panel-upgrade rebate and make-ready wiring support, with a higher tier when the household enrols in its EV programme, and an application window that runs after the installation.

Programme levels move and terms are per-provider, so we point you at the co-op’s current page rather than quoting a figure that may already be out of date. We do not file the rebate on your behalf.

Dedicated 240-volt charger circuit and breaker at a Firestone residential panel.
Illustrative design concept of a Firestone project.

Permits in Firestone

The Town of Firestone Building Division at 9950 Park Avenue, 303-833-3291, issues the permit through the CitizenServe portal and performs the inspection in house, under the 2023 National Electrical Code. Approved stamped plans and the permit card have to be on site or the inspection does not happen — a small rule that ruins a scheduled day if the paperwork is still in a truck.

The final-stage list includes confirmation that the added load does not overload the panel, continuity of the required drywall through garage walls and ceilings, the interconnected heat detector, and a document on company letterhead signed by the master electrician confirming that the lugs and terminals were torqued to specification.

Electricians also need a Town of Firestone contractor licence: no fee, but proof of state licensure and a certificate of insurance naming the Town as certificate holder and additional insured, renewed annually.

What Install Day Looks Like

A straightforward garage install is one day: the run from the panel, conduit where the path is exposed, the mounted charger, the breaker, the heat detector interconnection and the commissioning test with the car. Where the panel is at the far end of a finished basement, the path decides the day rather than the charger.

Long runs, a detached garage on its own slab, or a driveway pedestal for a car that parks outdoors all add scope. We walk the route before quoting.

What Moves the Price

Distance and difficulty of the run is the largest variable, then whether the panel has capacity and spaces, whether a subpanel is needed, whether the unit is hardwired, and whether the heat detector interconnection requires running a new cable through finished space. Permit fee and any plan review sit on top.

Related Work in Firestone

If the service is the constraint, the Firestone panel replacement page covers the arithmetic and the Town’s fee tiers. For the same work elsewhere, read the Windsor EV charger page or the Longmont page, or browse our service area.

N8
N8
★★★★★
Google

“Excellent experience from Bid to Completion. Thoroughly explained what to expect and the job was completed quickly and correctly. Hole cut, new box and wiring. Guys were professional and were happy with the results!”

Frequently Asked Questions

Do I need a permit to install an EV charger in Firestone?

Yes. The Town requires a permit with a load calculation, equipment specification, floor plan and wiring diagram, and inspects the work with its own inspectors.

What is the heat detector requirement?

Firestone’s adopted amendment requires a heat detector wired into the home’s smoke alarm system when a charger is installed in an attached garage. It is an interconnection, not a standalone device.

Will my panel carry a 48-amp charger?

That is what the load calculation decides. A 48-amp charger needs a 60-amp breaker and a service with room for a continuous load of that size; on a 100-amp service with electric heat, a lower-amperage circuit is often the honest answer.

Who supplies Firestone and which rebate applies?

United Power, the member-owned co-operative. Its residential EV panel-upgrade and make-ready programmes are the ones that apply; Xcel’s are not.

How long does the installation take?

A straightforward garage install is often one day. Long runs, a detached structure or a service upgrade extend it, and the inspection depends on the Town’s schedule and on the plans and permit card being on site.

Can you install a charger I bought myself?

Yes, provided the unit is listed for the application and its settings match the circuit we install. We check the equipment specification against the circuit before the permit goes in.

Request an EV Charger Quote in Firestone

Send a photo of the open panel, a photo of the bill, and the wall where the charger will go. Precision Service Electric is family owned, in business 30 years, licensed and insured under Colorado license #3918, factory-trained and an authorized Generac dealer, and rated 4.8 stars across 47 Google reviews. Call 970-593-3190 or request a quote.

Skip to content